Panasonic KX-TD816 - CO Line Connection

2.3.2 CO Line Connection
(KX-TDS16: CO1 through C04, ICY-TD1232: CO1 through CO8)
Using Modular Connector (for KX-TD816, KX-TD1232)
Connection
Insert the modular plugs of the telephone line cords (4-conductor
KX-TD816
wiring) into the modular jacks on the system.
R: Ring
T: Tip
I
Use 4-conductor wiring cord ‘ii’
-c
To Terminal Board or Modular
Jacks from the Central Office.
KX-TD1232
Use 4-conductor
T2 Rl Tl R2
R: Ring
T: Tip
View of TEL Jack (CO)
To Terminal Board or Modular
Jacks from the Central Office.
Notice l Use twisted pair cable for installation.
l It is recommended to use the telephone CO jacks of FU14C.
l Mis-connection may cause the system to operate improperly. See
_
Section 6.1.1 “Installation” and 6.1.2 “Connection” before connection.
2-14 Installation