407-408
45
0
CO Line Programming
DIL 1:l Extension
- Day / Night
Description
The Direct In Lines (DIL) 1: 1 feature allows incoming CO calls to
be directed to a specific extension. When a CO line is assigned as
DIL 1: 1, it is necessary to assign the destination. These programs
specify the extension number for day or night mode.
Selection
Default
All CO lines - Disable - Day / Night
Programming
1.
Enter a
program address (407 for day or 408 for night).
Display example: DIL 1:l Asn Day
Press
NEXT.
l
CO line number:
RX-TD8 16;
01 through 08, * ( I
=a11 CO lines)
RX-TD 1232;
01 through 24, I ( *
=a11 CO lines)
l
Extension number: 2
through 4 digits / Disable
(no DIL 1: 1)
2.
3.
4.
Display: CO Line NO?->
Enter a CO
line number.
To enter
CO
line number 0 1, you
can also
press NEXT.
Display example: COOl:Disable
Enter an
extension number.
To change the current entry, press CLEAR and the new number.
To disable DEL 1: 1, press CLEAR.
5.
6.
Press
STORE.
To program another CO line, press
NEXT
or
PREV,
or
SELECT
and the desired CO
line number.
7.
Repeat steps 4 through 6.
8.
Press
END.
Conditions
l
In the case of
KX-TD1232, COO1
through CO12 are for the Master
System and CO 13 through CO24 are for the Slave, if available. CO
line numbers in the out-of-service system are unacceptable.
. To assign all CO lines to one selection, press the * key at step 3. In
this case, the display shows the contents programmed for Cool.
l
You set the extension numbers in program [003] “Extension Number
Set” or floating numbers of pagers, DISA* messages and the modem*
in program [8 131 “Floating Number Assignment.”
: -
4-86
System Programming *: Available for KX-TD 1232 only.
To Next Page
Loading...
