Panasonic KX-TD816 - Page 493

990
Optional Programming
System Additional Information (contd.)
ma Field Descriution Selection 1 Default 1 References
05 ( (33) ( Unused
(34) Sets the time the system waits for IRNA
after the OGM.
(35) Selects the result when an outside call is
routed by Call Forwarding to a voice mail
port which is in Automated Attendant (AA)
service mode. [For both Inband and Digital
Proprietary Telephone (DRT) Integration]
disable : AA service mode
enable : The mode will change to the
Voice Mail (VM) service mode
and a Follow-On ID is sent.
When the voice mail port is in VM service
mode, this program is not affected.
(36) Selects the result when an outside call is
routed to a voice mail port by IRNA.
[For both Inband and DPT Integration]
When the voice mail port is in VM service mode
enable : VM service mode
disable : The mode will change to the AA
service mode. [Only when Inband
When the voice mail port is in A4 service m&k
enable : The mode wilI change to the VM
service mode and a Follow-On ID
is sent.
disable : AA service mode
0 : immediately
1: after 5 seconds
0 : disable
1 : enable
0 : enable
1 : disable
1 Voice Mail
Integration
I
1 (37) 1 Unused
I I
(38) Enables or disables dial tone 2 when an
extension sets programmable extension
features such as Call Waiting.
(39)
Determines the result when pressing the
FLASH button during an outside call
(When Field 3=0).
Flash: Disconnects and accesses the same
outside line.
0 : disable
1 : enable
0 : Terminate
1:Flash
Terminate: Terminates the outside line and
accesses the intercom. It is
convenient to route the outside call
I I
according to Automatic Route
Selection (AR9 if ARS is active.
1
None
1
Flash
\ I
(40) Selects the message waiting ring type: 3
0: 3timesby4Oms 1
Message Waiting
quick rings or 2 normal rings, for standard
1: 2 timesby
telephones.
280ms
18