2.4.4 Installing Expansion Unit
’
(KX-TD170 / KX-TDl80)
KX-TD1232
The following procedures can be used to install either 8-Station Line
Unit (KX-TD170) or 4-CO Line Unit (KX-TD180) for KX-TD1232.
The following steps 1 through 5 and 7 through 10 are common to
both expansion cards.
The step 6 shows two different methods to install respective
expansion units.
1.
Loosen two screws on the cover plate.
3. Hook the cabinet on the main unit and
Insert fingers into the slits to remove the
slide the cabinet to the left until it is
cover plate.
Slit
fixed.
Note There are three cover plates. Any of
them can be removed, as needed.
4. Loosen the outside screw and slide the
2. Connect the cabinet cord to the
connector in the main unit firmly.
cover to the right.
c
,::
1
O&de screw
Installation
To Next Page
Loading...
