Panasonic KX-TDA50 - Page 144

Programming Manual References
None
Feature Manual References
3.1.13 CLIP (Calling Line Identification Presentation)
Ringback Tone to Outside Caller
Enables the PBX to send a ringback tone to an outside caller when the network cannot send the tone.
Default
Enable
Value Range
Disable, Enable
Maintenance Console Location
3.14 [1-1] Slot—Port Property - PRI Port (KX-TDA100/KX-TDA200/KX-TDA600 only)
Programming Manual References
None
Feature Manual References
None
ISDN In/Out Call Type
Selects the method used to send dialed digits to the network.
Default
CO port: En-bloc
QSIG (slave/master) port: Overlap
Value Range
En-bloc: The PBX sends all of the dialed digits at once after the extension user completes dialing. The PBX
recognizes
the end of dialing when (1) # is dialed, if programmed, (2) a preprogrammed telephone number is
dialed, or (3) the inter-digit timer expires.
Overlap: The PBX sends dialed digits one at a time.
Maintenance Console Location
3.14 [1-1] Slot—Port Property - PRI Port (KX-TDA100/KX-TDA200/KX-TDA600 only)
Programming Manual References
3.1 [1-1] Slot
4.4 [2-3] Timers & Counters—Dial / IRNA / Recall / Tone—
Dial—Extension Inter-digit
144 PC Programming Manual Document Version 2010-11
3.14 [1-1] Slot—Port Property - PRI Port (KX-TDA100/KX-TDA200/KX-TDA600 only)