Panasonic KX-TDA50 - Page 145

4.17 [2-9] System Options—Option
2—
End of Dial Plan—[#]
as End of Dial for en Bloc mode (KX-TDA100/
KX-TDA200/KX-TDA600 only)
5.4 [3-1-4] Dialing Plan
Feature Manual References
9.1.16 ISDN (INTEGRATED SERVICES DIGITAL NETWORK) FEATURES
Networking Data Transfer
Enables transmission of extension status data to connected PBXs in a network. This setting is only available
when Port Type on this screen has been set to QSIG-Slave or QSIG-Master.
Default
No
Value Range
No, Yes
Maintenance Console Location
3.14 [1-1] Slot—Port Property - PRI Port (KX-TDA100/KX-TDA200/KX-TDA600 only)
Programming Manual References
Section 11 [9] Private Network
Feature Manual References
13.1.15 Private Network Features—NDSS (Network Direct Station Selection)
Loopback Test started by Network
Enables a loopback test started from the network side, to be performed on the PRI23 card.
Note
The version of the PRI23 card must be 2.000 or later.
Default
Disable
Value Range
Disable, Enable
Maintenance Console Location
3.14 [1-1] Slot—Port Property - PRI Port (KX-TDA100/KX-TDA200/KX-TDA600 only)
Programming Manual References
Network Loopback Test (KX-TDA100/KX-TDA200/KX-TDA600 only)
Document Version 2010-11 PC Programming Manual 145
3.14 [1-1] Slot—Port Property - PRI Port (KX-TDA100/KX-TDA200/KX-TDA600 only)