To Next PageTo Next Page
Why does redialing not function on my Panasonic Telephone System?
Redialing may not function on your Panasonic Telephone System if the stored number was more than 32 digits or an extension number.
Why is there noise on external paging with my Panasonic KX-TDA50?
Noise on external paging with a Panasonic PBX is often due to induced noise on the wire between the PBX and the amplifier. To resolve this, use a shielded cable as the connection wire. A short shielded cable is recommended.
How to fix Panasonic Telephone System when personal settings do not work?
If your Panasonic Telephone System does not work using the personal settings or with other settings (One-touch dialing, forwarding destination, etc.), it is possible that the extension line has been changed. The previous telephone’s settings have not been cleared, so clear the settings and then program your desired settings again.
What to do if Panasonic KX-TDA50 PBX has CO line connected to the T2/T1?
To fix a Panasonic PBX with a CO line connected to the T2/T1 (or T2/R1), reconnect the CO line to the T1/R1 or T2/R2 of the telephone jack using 2-conductor wiring.
How to fix Panasonic PBX when using speakerphone on an APT, nothing is audible?
If you can't hear anything when using the speakerphone on an APT (or speakerphone/monitor mode with a DPT) with your Panasonic PBX, it might be because the HANDSET/HEADSET selector is set to the "HEADSET" position, or the "HEADSET" mode is selected by Personal Programming. When the headset is not in use, set the HANDSET/HEADSET selector to the "HANDSET" position or select the "HANDSET" mode by Personal Programming.
What to do if Panasonic KX-TDA50 PBX Alternate Calling—Ring/Voice and Live Call Screening (LCS) do not function as set when using a Wireless Phone?
Voice-calling mode and Hands-free mode with LCS are not available with Wireless Phones on Panasonic PBX. Switch the calling mode to ring-calling or set the LCS mode to "Private".
What to do if my Panasonic proprietary telephone does not have a feature button?
If your Panasonic proprietary telephone does not have a feature button, it may be because some models do not have the feature button. In this case, change a flexible button to the desired button.
How to fix Panasonic Telephone System when some features do not work?
If some features on your Panasonic Telephone System are not working, it could be because system management has restricted certain features, in which case you should consult your manager. It is also possible that the feature numbers have changed, so confirm the revised number and try again.
What to do if my Panasonic Telephone System does not respond when buttons are pressed?
If your Panasonic Telephone System is not responding when buttons are pressed, it could be due to a couple of reasons. First, the telephone might be locked, in which case you should unlock it. Alternatively, your telephone might be connected to an eXtra Device Port, and in this case system programming is required, so you should consult your dealer.
Why does my Panasonic Telephone System disconnect during outside calls?
The line may be disconnecting because the time limit has run out. If necessary, consult your dealer to extend the time limit.
General