14. Menu Guide
346
[Monitor / Display] ¨ ¨
[Zebra Pattern]
[ZEBRA1]/[ZEBRA2]/`[OFF]
[SET] [Zebra 1]/[Zebra 2]
This indicates areas where overexposure may occur in a
zebra pattern.
[ZEBRA1] [ZEBRA2]
Select [SET] to set the brightness to be processed as a
zebra pattern.
0 You can select a brightness value between [50%] and
[105%].
In [Zebra 2], you can select [OFF].
If you select [100%] or [105%], only the areas that are
already overexposed are displayed in a zebra pattern.
The smaller the value is, the wider the brightness range to
be processed as a zebra pattern will be.
0 This menu item can be registered to the Fn button.
(l 278)
To Next Page
Loading...
