16. Connecting to Other Devices
439
Operating the Camera from a PC
Getting started:
0 Turn on the camera and PC.
0 Install “LUMIX Tether” on PC.
1
Connect the camera and PC with the USB connection
cable (C–C or A–C).
0 Plug in/out straight holding onto the plug.
(Inserting these at an angle may cause deformation or malfunction)
0 Do not connect the cable to the wrong terminals. This may cause a
malfunction.
2
Press 34 to select [PC(Tether)] and then press or
.
≥[ ] is displayed on the screen.
0
A message about charging may be displayed. Wait for a while until the
message disappears.
3
Use “LUMIX Tether ” to operate the camera from the PC.
0 To output via HDMI to an external monitor or TV, connect the camera and
external monitor or TV with an HDMI cable. (l 426)
To Next Page
Loading...
