15. Wi-Fi/Bluetooth
376
End Bluetooth Connection
To terminate the Bluetooth connection, turn off the Bluetooth function of the
camera.
¨ [ ] ¨ [ ] ¨ [Bluetooth] ¨ [Bluetooth] ¨ Select [OFF]
Connecting to a Paired Smartphone
Connect paired smartphones using the following procedure.
1
Enable the Bluetooth function of the camera.
0
¨ [ ] ¨ [ ] ¨ [Bluetooth] ¨ [Bluetooth] ¨ [ON]
2
On the smartphone, start up “LUMIX Sync”.
0
If a message is displayed indicating that the smartphone is searching for
cameras, close the message.
3
Select [ ].
4
Select [Bluetooth Setup].
5
Turn Bluetooth ON.
6
From [Camera registered] items, select
the camera’s device name.
0 (iOS devices) If the Wi-Fi connection attempt fails during Bluetooth
connection, follow the message displayed to allow connection to the camera.
If you still cannot connect, select the SSID of the camera on the Wi-Fi setup
screen of the smartphone to connect. If the SSID is not displayed, turn off and
on the camera, then perform the Bluetooth connection settings again.
0 Even if you terminate the connection, the pairing information for it will not be
deleted.
LUMIX Sync
Bluetooth
XXXXXXXX
To Next Page
Loading...
