16. Connecting to Other Devices
434
2
Press 34 to select [PC(Storage)] and then press or
.
0 A message about charging may be displayed. Wait for a while until the
message disappears.
3
Copy images to the PC using “PHOTOfunSTUDIO”.
0 Do not delete or move the copied files and folders in, for example, Windows
Explorer.
Playback and editing using “PHOTOfunSTUDIO” will become no longer
possible.
Copying to a PC Without Using “PHOTOfunSTUDIO”
Even if you are using a Mac, or in any situation where
“PHOTOfunSTUDIO” cannot be installed, you can still copy files and
folders by connecting the camera to the PC and then dragging and
dropping them to it.
0 If [USB Mode] is set to [PC(Storage)] in the [Setup] ([IN/OUT]) menu, the
camera will be automatically connected to the PC without the [USB Mode]
selection screen being displayed. (l 355)
0 Do not use any other USB connection cables except the supplied USB
connection cables (C–C and A–C).
0 Take care not to turn off the camera while images are being imported.
0 After importing of the images is completed, perform the operation to safely
remove the USB connection cable on the PC.
0 Turn off the camera and disconnect the USB connection cable before
removing the card from the camera. Otherwise, the recorded data may be
damaged.
To Next Page
Loading...
