11 Standards and Certifications
Standards and CertificationsStandards and Certifications
Standards and Certifications
108
07-02-12-02-EN-V1215.doc / Type: 638
11 Standards and Certifications
11.1 Compliance with Regulations, Limitations and Basic Conditions
European Directives
EG Low-Voltage Guidelines
2006/95/EC
In accordance with EN61800-5-1
Safety requirements – Electrical, thermal and energy.
EG-EMC-Directive
2004/108/EC
EN 61 800-3, Emissions and immunity levels for
Power drive systems.
UL - Approved
Underwriter Laboratory Standard
UL 508 C Power Conversion Equipment
Canadian Standards Association
C22.2 No.14 (only
638A)
Power Conversion Equipment
UL File-No. e235342
Insulation Requirement
Protection Class
EN 50 178 I
Overvoltage Category
IEC 60364-4-443:1999 III
Pollution Degree
EN 61800-2, 4.1.2.1 2
Environmental Conditions
General Environmental
EN 61800-2
Ambient Temperature Rating:
Operations
Storage
Transport
IEC 60721-3-3
IEC 60721-3-3
IEC 60721-3-2
+ 5 bis +40 °C, 3K3
-25 bis +55 °C, 1K4
-25 bis +70 °C, 2K3
Allowable Humidity:
Operations
Storage
Transport
IEC 60721-3-3
IEC 60721-3-3
IEC 60721-3-2
<= 85% non-condensing, 3K3
<= 95%, 1K4
<= 95% at +40 °C, 2K3
Vibration:
EN60068-2-6
Test FC
10Hz ≤ f ≤ 57Hz sinusoidal
0,075mm amplitude
57Hz ≤ f≤150Hz sinusoidal 1g
10 sweep cycles per axis
1 Oktave / Minute
Air Pressure
86 kPa – 106 kPa
Protection
EN 60529 IP20
Altitude
Under <= 1000m above sea level with 100%
power rating
Over >1000m .. <= 2000m above sea level, decrease
the power rating by 1% per 100m
Method of Cooling
638B 03 Convention cooling
All 638A,
638B05 /08 /10 /15
Forced ventilation (internal fan)
To Next Page
Loading...
