Installation
6400
2
15
Communication Connections
There is a Universal Serial Bus (USB) port at the
rear of the calorimeter.
The USB port is used to connect to external de-
vices such as a printer or balance. Multiple devices
can be attached by installing a USB hub.
The 6400 Calorimeter is also equipped with an
RJ45 Ethernet port for connection to a computer.
The 6400 will also allow the user to specify the
IP addresses of one or more Balance Interface
devices on the network by selecting the NETWORK
DATA DEVICE menu in the COMMUNICATIONS
CONTROLS menu. Balance Interface devices are
polled from device 1 to 15 for sample and/or spike
weights when the weight entry mode is set to
Network.
See Chapter 12 - Communication Connections for
more information.
Printer and Balance Connections
Connect the printer to the calorimeter at this time.
The ynapmoC 1759 Printer is configured and furnished
with a cord to connect directly to the USB port on
the back of the calorimeter. The printer settings are
on the COMMUNICATION CONTROLS menu. The
default parameters for the 6400 are set up for use
with the ynapmoC 1759 Printer.
If a balance is to be attached to the calorimeter it
will be necessary to use a USB hub so that multiple
devices can be connected. Any standard USB hub
can be used.
See Chapter 12 - Communication Interfaces for
more information.
To Next Page
Loading...
