Program Installation & Control
3
16
chaPter 3
Program Installation & Control
Programming
The program in the 6400 Calorimeter can be extensive-
ly modified to tailor the unit to a wide variety of operat-
ing conditions, reporting units, laboratory techniques,
available accessories and communication modes. In
addition, the calculations, thermochemical corrections
and reporting modes can be modified to conform to
a number of standard test methods and procedures.
Numerous provisions are included to permit the use of
other reagent concentrations, techniques, combustion
aids and short cuts appropriate for the user’s work.
Note: Changes to the program are made by use of
the menu structure described in Chapter 5 of this
manual. Any of these items can be individually en-
tered at any time to revise the operating program.
Default Settings
Units are pre programmed with default settings. A
more in-depth explanation of these parameters is
found on the corresponding parameter group help
pages within the software. These default settings
remain in effect until changed by the user. Should the
user ever wish to return to the factory default set-
tings, go to the PROGRAM INFORMATION & CON-
TROL menu, USER/FACTORY SETTINGS, RELOAD
FACTORY DEFAULT SETTINGS and confirm YES.
User Default Settings
The user parameters of the 6400 Calorimeter can
be saved to guarantee that the desired calorimeter
configurationcan always be recalled before beginning
a series of tests. Users who wish to permanently save
their default settings may do so using the following
procedure:
1. Establish the operating parameters to be stored
as the user default settings.
2. Go to the PROGRAM INFO & CONTROL menu,
USER/ FACTORY SETTINGS, USER SETUP ID, and
enter the desired User Setup ID.
3. Select SAVE USER DEFAULT SETTINGS
To re-load the user default setting, go to the PROGRAM
INFO & CONTROL menu, USER/FACTORY SETTINGS,
RELOAD USER DEFAULT SETTINGS, and confirm YES.
Non-volatile memory is provided to retain any and all
operator initiated program changes; even if power is
interrupted or the unit is turned off.
Factory Default Settings
Calorimeter Operations
Operating Mode Determination
Bomb Installed/EE 1/940.0
Heater and Pump OFF
Operating Controls
Method of Operation Dynamic
Reporting Units BTU/lb
Use Spiking Correction OFF
“OTHER” Multiplier 4.1868
LCD Backlight Timeout(s) 1200 S
Print Error Messages ON
Language English
Spike Controls
Use Spiking OFF
Heat of Combustion of Spike 6318.4
Use Fixed Spike OFF
Weight of Fixed Spike 0
Prompt for Spike before Weight OFF
Bomb Rinse Tank Control
Report Rinse Tank Empty ON
Rinse Tank Capacity 150
# Rinses Left 150
Reset Rinse Tank Counter
Rinse Time 25
Rinse Flush Time 20
Clear Time 100
# of Rinse Cycles 3
Program Information and Controls
Date XX/XX/XXXX
Time XX:XX
Volume Level Adjust 85%
Software and Hardware Info
Settings Protect OFF
User/Factory Settings
Feature Key
Bomb Type Select
User Function Setup
Cold Restart
User/Factory Settings
User Setup ID 64-1138
Reload Factory Default Settings
Reload User Default Settings
Save User Default Settings
Calibration Data & Controls
Calibration Run Limit 10
EE Max Std Deviation 0
Heat of Combustion of Standard 6318.4
Bomb Service Interval 500
Use Bomb 1
To Next Page
Loading...
