Particle Measuring Systems LASAIR II 550L User Manual

Using the Remote Mode
Lasair II Particle Counter Operations Manual Page 7-7
NOTE: The instructions in this chapter assume that you are familiar
with using either Internet Explorer or Netscape Communicator
browser software.
For more information, see Appendix B, "Connecting to a Computer or Network".
Setting for 0.5 and 5.0 μ m Output Only
The Communications Setup Screen (Data) may be set to cause output with 0.5 and
5.0 μm output only. See Appendix H, "Pharmaceutical (Two-channel) Output
Mode".
Using the Remote Mode
“Remote mode” means that Lasair II particle counter will not be permanently
connected to any other communications or control network while it is collecting
data. That is, it is used in a stand-alone mode to collect data from multiple locations.
Periodically, the particle counter is connected to an Ethernet network to download
its accumulated data to Facility Net. The downloaded data can then be stored in a
digital file which has few if any size limitations and which can be backed up. Also,
the data will then be available to analytical and graphical software.
Figure 7-4: Comm Setup Screen, Data

Particle Measuring Systems LASAIR II 550L Specifications

General

Brand	Particle Measuring Systems
Model	LASAIR II 550L
Category	Measuring Instruments
Language	English