Page 3-2 Lasair II Particle Counter Operations Manual
Chapter 3: Controls and Displays
To turn the particle counter on and off:
Press the On/Off key.
To darken or lighten the screen:
Press the Minus or Plus key until the screen darkens or lightens to
the desired contrast.
To start sampling:
Press the Start key. The Start key works from any screen. Pressing it will return
you directly to the Main Display Screen.
To stop sampling: Press the Stop key.
To activate the edit mode on a setup screen: Press the Enter key.
To move the cursor while in edit mode:
press the Left or Right arrow key.
To increase or decrease a value while in edit mode:
Press the Up or Down arrow key.
To enter a setup selection into the system: Press the Enter key.
Hierarchy of Screens
The Lasair II particle counter uses a hierarchy of screens and displays. By
becoming familiar with the following hierarchy, you can navigate to the menus and
displays with greater ease.
WARNING
This is not a power disconnect. To remove power, unplug the power cord
and remove the battery.