Recipe Setup Screen
Lasair II Particle Counter Operations Manual Page 9-5
Recipe Names
Recipe names may be up to 16 characters. The following characters are illegal in
recipe names: \, /, *, ?, “, <, >, :, and |.
Figure 9-2, “Setup Screen, Locations Page,” on page 9-7, shows the location
association page of the Recipe Setup Screen. This display is a table of all the
locations and recipe associations. Each recipe can be associated with multiple
locations.
To select a recipe to run at a location:
1 Open the Recipe Screen-Location Page
2 Press the blue enter key, to enter edit mode.
3 Use the tab or back-tab soft-keys to move the cursor into the recipe column.
4 Use the up and down arrows (or the +10, -10 soft-keys) to move to the desired
location.
5 If you are unable to select a location, move the cursor to the recipe Sort radio
button and press the Enter button. Repeat step 3.
6 Press the blue enter key. This displays the list of recipes that can be initiated by
the chosen location.
Figure 9-1: Recipe Setup Screen, Setup Page
To Next Page
Loading...