Particle Measuring Systems LASAIR II 550L User Manual

Observing Statistical Results
Lasair II Particle Counter Operations Manual Page 8-17
When Not Using the Auto-increment Mode
If you have not enabled auto-increment, the
following dialog box will be displayed when
sampling is completed at a location:
To select the next location name and
continue sampling:
1 Press the Enter button to close the Statistics
Update dialog box.
2 Open the Sampling Setup screen.
3 Press the Enter button to activate the edit mode. The location selection box will
be active when the screen changes to the edit mode.
4 Use the up and down arrow buttons to highlight the location name you want to
use for the next sample.
5 Accept the location name and navigate to the Main Display.
6 Move the particle counter to the location that matches the location name you
have selected.
NOTE: You could have moved the Lasair II particle counter to the
next location at any point before pressing the Start button.
7
Ensure that the proper location appears on the display and then press the Start
button to collect the next sample
8 Move the particle counter to the next sampling location and continue sampling
until all locations are sampled or terminate sampling if you must.
Observing Statistical Results
Sample results are displayed in the Statistics Summary screen and the Statistics
Table after each sample is completed.

Particle Measuring Systems LASAIR II 550L Specifications

General

Brand	Particle Measuring Systems
Model	LASAIR II 550L
Category	Measuring Instruments
Language	English