Appendix M: Touch RAM
Page M-8 Lasair II Particle Counter Operations Manual
➢ If old data is in the particle counter, then an error message says: “TouchRAM
conflict. Data on box must be erased before loading new TCP/IP address”.
TouchRAM information is not loaded. See Figure M-4, “Notification to
Delay TCP/IP Change,” on page M-8.
➢ If no data is stored in the Lasair II particle counter’s database, all old
location names in the database will be erased. The Lasair II particle counter
will then:
➢ Load the new location name and sampling parameters
➢ Set the new TCP/IP address
➢ Reboot the box to load the addresses. When the Lasair II particle counter
reboots, it is ready to take a sample.
Figure M-3: Notification Allowing New TCP/IP Address
Figure M-4: Notification to Delay TCP/IP Change
To Next Page
Loading...