Particle Measuring Systems LASAIR II 550L User Manual

TouchRAM Button Data Format
Lasair II Particle Counter Operations Manual Page M-5
TouchRAM Button Data Format
The following data is written on Lasair II particle counter buttons:
[ANALOG_SETUP_PARAMETERS] This group is not supported in recipes
T_RH ENABLED
TRH_UNITS
Analog1_Enabled Analog3_Enabled
Analog2_Enabled Analog4_Enabled
[SAMPLING_SETUP]
InterSampleDelay SampleTime Number_Of_Samples
Sample_Normalized Continuous sampling
mode
Location
SampleVolumeCF or CM Enable_Sample_By_Time SamplePurgeTime
Sample_Units Group Repeat Enabled
Print Average Flag (Older software will read: Default 0)
[GLOBAL_ALARMS]
Enabled Buzzer_Enabled
[PARTICLE_ALARMS]
Use_differential CH3_Counts CH5_Counts
CH1_Counts CH3_Enabled CH5_Enabled
CH1_Enabled CH4_Counts CH6_Counts
CH2_Counts CH4_Enabled CH6_Enabled
CH2_Enabled
[ANALOG_ALARMS]
ACH1_MIN ACH3_MIN ACH5_MIN
ACH1_MIN_Enabled ACH3_MIN_Enabled ACH5_MIN_Enabled
ACH1_MAX ACH3_MAX ACH5_MAX
ACH1_MAX_Enabled ACH3_MAX_Enabled ACH5_MAX_Enabled
ACH2_MIN ACH4_MIN ACH6_MIN
ACH2_MIN_Enabled ACH4_MIN_Enabled ACH6_MIN_Enabled
ACH2_MAX ACH4_MAX ACH6_MAX
ACH2_MAX_Enabled ACH4_MAX_Enabled ACH6_MAX_Enabled
[NETWORK_CONFIG] (optional)
TCP/IP_ADDRESS NETWORK_MASK TCP/
IP_REMOTE_MODE_ON
PMS Multi-Drop Address (Older software will read: Default 0)
CHECK_SUM

Particle Measuring Systems LASAIR II 550L Specifications

General

Brand	Particle Measuring Systems
Model	LASAIR II 550L
Category	Measuring Instruments
Language	English