23
Winding shaft
plate
(0-C34)
Equipment
to
be prepared: Driver bit 23400K-C73-A
1) Align C44
and
C94 (spring)
and
attach.
2) C43 (C43 will come
off
at
this state)
3) Attach
O-C3 by passing through the body from below.
(Apply
G21
to
the gears.)
4)
O-C34, C15
--0>
(C15 should be thoroughly press-fitted.)
5) C57 (Screw Jock, tools to be used), E93
6) C2, CNS 1.7 x4.5
Check: Check that the gears rotate smoothly.
7) C85, C84,
PT (4 x2.5), C60
CNL-Bl.4 x2.5
9)
C40, C35, C37, C83,
CNL-Dl.4
x2.5
Apply G151
to
tip
of
C35.
10) C96, C33,
CSSl.7
x2.5 x3
NB: Make sure that C96 does not intrnde
while turning C43.
2.4 Main
gear
(assy.)
(0
-Cl)
1) Release. the shutte.r curtain.
2)
Re.move.
O-E80 (curtain charge gear) and
O-D43 (mirror charge gear).
NB: Take care not to
Jose.
the
ste.e.J
balls.
12/70
27340
O-C3
To Next Page
Loading...
