Pentax 67 II - Front Cover; Left;Right Side Cover; Top Cover, Left; Winding Lever

1.5 Front cover, left (Al31)
1) 2 screws
1.6
Left side cover (0-AIOI)
1) 3 screws
2) Remove
0-AlOl as shown
in the drawing.
NB: A lead wire is attached to
the back
of the cover.
3) Remove the soldering of
the 6 lead wires on the main
circuit board.
1.7
Top cover, left (O-A351)
1) A33 x3
2) O-A351
* The shutter dial may be in any position.
1.8
Right side cover (0-All 1)
1) 4 screws
2) 0-Alll
Lift up the front and pull forwards.
1.9 Winding lever (C51)
1) C50
Wind up halfway and peel from
the notched groove
of CSO.
2) Wind up fully by C51 and put in
the
release state. (Use the battery.)
3) C51, 3 screws
A33
~A33
C51
27340
C NM 1.7X4.0
x 3 @ U3
ij I w
sno