Pentax 67 II User Manual

7) Solder 6 lead wires (lower side of body TlOO).
8) Using the guide of the mirror box, treat the lead wires
so that they do not come into contact with the gears
and the bounce mechanism.
-7
Purple
Pink
2.16 Mechanical back, mirror 45 degrees, mount lock pin (adjust)
Equipment to be prepared: Block gauge for 67,
Mount pedestal for 67,
1) Adjust: Mechanical back
Mirror
45 degree positioning jig for 67,
Slide calipers.
-1) Check:
Set the Back cover vertically and measure six places.
Standard:
84.95 +/- 0.04 mm
-2) Adjust: Remove the mount ring and adjust with
W8 (four places)
± 0.02 as the objective.
2) Adjust: Mirror
45 degrees
ed
White
a. b. c.
d. e. t.
-1) Check: In the winding completion state, place the jig against the mirror and the mount and make sure that there
;, nn g•p bo1w~ mimu. (Chock in tb.::" pl~"·) C
-2) Loosen Dl49 (2), screw in Di48 (2), and create a gap
between the mirror sheet and the damper
plate. (D132, D133).
-3)
Adjust 1: Adjust the mirror angle with D148 on the grip side.
-4) Adjust
2: Adjust to zero the gap between the mirror sheet
and
D133 with the other D148.
-5) Fix with D148 (2) and check again.
After adjusting
and checking, apply screw Jock D148.
27340
L1
nno

Pentax 67 II Specifications

General

Type	Medium format SLR
Film Format	120/220 roll film
Image Size	6x7 cm
Lens Mount	Pentax 67 bayonet mount
Metering	TTL center-weighted metering
Focusing Screen	Interchangeable
Mirror Lock-Up	Yes
Multiple Exposure	Yes
Shutter	Electronically controlled horizontal-travel cloth focal plane shutter
Shutter Speed Range	1/1000 to 4 s, Bulb
ISO Range	6 to 6400
Exposure Modes	Manual, Aperture Priority
Viewfinder	Interchangeable
Flash Sync Speed	1/30 s
Power Source	6V 4LR44 battery