Philips HD11 XE - Configuring and Using the Data Transfer Feature

4
HD11 XE Getting Started
4535 612 62651
105
Using the System
➤ To configure the foot switch
1. Press Setup on the system control panel.
2. Click the Peripherals tab.
3. In the Foot Switch section, click the down arrow associated with each pedal
to select from the following functions:
–Rec 1
–Rec 2
–Rec 3
–Freeze
4. Click Apply and then click Close to save your changes.
Configuring and Using the Data Transfer Feature
The Data Transfer feature allows patient report data to be sent through the sys-
tem’s RS-232 port to an offline printer, computer, or workstation.
For more information on the data transfer formats, contact your Philips represen-
tative.
Assigning a Record Key
Before you can use the Data Transfer feature to transfer study data, you must
configure the system by assigning Serial Output to one of the record keys.
➤ To assign a record key
1. Press Setup and click the Peripherals tab.
2. Select Serial Output as the device to associate with a record key.
3. Click Apply, and then click Close.