Using the System
HD11 XE Getting Started
4535 612 62651
4
90
Configuring Network Settings
This section provides the information needed to configure the network settings
on the system. It includes:
• “Configuring the System’s Network Settings” on page 90
• “Adding a DICOM Server” on page 91
• “Associating DICOM Servers with Roles” on page 92
• “Checking the DICOM Job Manager” on page 93
For a list of the DICOM options available for the system, see Table 3-12. For
information about enabling options on your system, see the Help.
Configuring the System’s Network Settings
Before you can connect to a DICOM network, you need to configure the system’s
network settings. Check with your system administrator for the specific values
that you need to enter.
➤ To c o n f i g u r e t h e s y s t e m ’s n e t w o r k s e t t i n g s
1. Press Setup to open the Setup window.
2. Click the System tab.
3. Click the DICOM button.
4. In the DICOM Preset tab, verify that the correct preset is displayed. If not,
click Change DICOM Preset and select the preset.
5. Click Change Settings for current preset.
6. In the This System tab, type the AE title that the network administrator
assigned to this system.
7. Set the Port number to the number assigned to the system by the network
administrator.
8. Click Network settings.
To Next Page
Loading...