Cleaning and Maintaining the System
HD11 XE Getting Started
4535 612 62651
5
116
CAUTIONS
• Use only compatible disinfectants on system surfaces.
• If you use an isopropyl alcohol solution for disinfection, ensure the solution is
only 70% isopropyl alcohol or less. Solutions of more than 70% isopropyl alco-
hol can cause product damage.
➤ To c l e a n a n d d i s i n f e c t s y s t e m s u r f a c e s
1. Turn off the system and disconnect the system power cord from the wall out-
let.
2. Use a soft cloth lightly dampened in a mild soap or detergent solution to clean
exterior surfaces on the system.
3. Mix the disinfection solution compatible with your system (see the list on
page 115) according to label instructions for solution strength.
CAUTION
Do not spray disinfectant directly on system surfaces. When wiping, do not allow
disinfectant to pool or run on system surfaces. In either case, disinfectant may
leak into the system, damaging the system and voiding the warranty. Wipe only
with a cloth or an applicator that is lightly dampened.
4. Wipe system surfaces with the disinfectant, following disinfectant label
instructions for wipe durations, solution strengths, and disinfectant contact
duration. Ensure the solution strength and duration of contact are appropriate
for the intended clinical application.
5. Air dry or towel dry with a sterile cloth according to the instructions on the
disinfectant label.
To Next Page
Loading...