4
HD11 XE Getting Started
4535 612 62651
85
Using the System
to create more than 180 presets, you can save presets to a CD and restore them
when you need to use them.
NOTES
• Presets are only available if you purchased the corresponding application pack-
age option.
• The system contains application presets and DICOM presets. Unless DICOM
is specified, when preset is mentioned in the documentation, it is referring to
application presets.
You can save multiple sets of DICOM configuration settings by using DICOM Pre-
sets. For example, if you move your system among departments that use different
DICOM settings, you can create a preset for each department and then easily
change your system to a different DICOM preset each time you move the system.
It is important to make a backup copy of your presets to preserve them in the
event of a hard disk drive failure, or before you upgrade your system software.
For more information, see “Making Backups” on page 86.
For more information about presets—including how to create, select, delete,
modify, save, and restore presets—see the Help.
Changing and Saving System Settings
➤ To change system settings
1. Press Setup and click the System tab.
2. To apply your changes to the current state of the system, make the changes
and click Apply or Close.
3. To save your changes to a preset, click Save.
For detailed instructions on how to change specific settings, see the Help.
Installing, Removing, and Disabling Options
When you receive your system, the options you purchased are installed and
enabled. At some point, however, you may need to install a new option, to
remove an option, or to disable an option.
To Next Page
Loading...