7-12 SV63136 Rev. A
7 • Add-On Modules
Figure 7.15: Connect+ Side Guide (shown without MMI)
NOTE: Refer to the Operator Guide for you mailing system for more informa-
tion about processing mail.
5. Adjust the side guide to the width of an envelope that will be used. See
figures below for Connect+ requirements.
NOTE: The MMI does not support ats.
Figure 7.16: Clearance Between Envelope and Side Guide
1/8 - 1/4”
Clearance
between en-
velope and
Side Guide
To Next Page
Loading...
