Setup & User Guide
| 130
DOC-246-GDE-Pivot3 Acuity 2.3 Setup & User Guide-v1.0.docx
Next, type ip and the IP address to be assigned to the SAN NIC port. Example:
ipset>ip 10.3.15.145
Next, type netmask followed by the subnet mask value. Example:
ipset>netmask 255.255.255.0
Optionally, to set a gateway, type gateway and the gateway IP address. Example:
ipset>gateway 10.3.15.1
NOTE:
Do not set default gateway on SAN or Management NICs.
Repeat Steps 6 – 11 to set the static IP address configuration for the second SAN NIC port, replacing 0 with 1 in Step 8.
Repeat Steps 6 – 11 to prepare the IP address configuration for the Management NIC port, replacing san0 with mgmt0
in Step 8.
If there is a DHCP server on the network, the IP address for the Management NIC can be quickly set by typing ip dhcp. The
Management NIC is the only port that can be set this way.
Type print at the ipset> prompt to review the values entered for all available NIC ports.
If all the information is correct, type set to retain all the information input in previous steps.
NOTE:
The setip function cannot be performed on nodes in vPGs. The IP address can be modified later.
Exit the utility by typing quit at the ipset> prompt.
Press <Alt> and <F1> at the same time to return to the status console screen.
To Next Page
Loading...