Foot control: When all the instruments are in their holders you can fill the cup
either by briefly pushing the pedal down twice or by pushing down the pedal
once until the filling starts (0,5 - 1 sec.). The unit will automatically fill the cup
and then rinse the bowl. Cup filling stops automatically after a preset time.
Cup filling can be stopped before it stops automatically by pushing the pedal
briefly down.
If the pedal is pushed for longer than 1 second, water flows for as long as
the pedal is pushed, and the bowl is not rinsed.
The flow rate of the cup fill can be adjusted by turning the black knob inside
the unit, see section "Adjusting cup fill and bowl rinse flow rates" on page
192.
The duration of the cup fill can be programmed, see section "Duration of cup
filling" on page 192.
Patient's cup fill button (optional)
The patient can fill the cup by pressing the patient's cup fill button on the
cuspidor. The water flows for as long as the button is pressed.
1 Patient's cup fill button
22.4 Timer
About this task
The timer memory contains six preprogrammed time settings. Follow the
steps below to activate a timer.
NOTE
Other functionalities can be used while the timer is running.
NOTE
The timer can not be run from the foot control.
Steps
1. Press Timer to open a list of available timers.
22 Operating dental unit
116 Planmeca Compact i User's manual
To Next Page
Loading...
Need help?
General
