ENGINE
3.13
Rocker Arm & Support I.D.:
.8669-.8678I (22.020- 22.041 mm)
7. Measure I.D. of both rocker arm shaft support
areas and visually inspect surface. Compare to
specifications.
Rocker Shaft Oil Clearance:
Std: .0008-.0021I (.020- .054 mm)
Limit: .0039I (.10 mm)
8. Inspectrockeradjusterscrewsforwear, pitting,or
damage to threads of the adjuster or locknut.
Replace all worn or damaged parts. NOTE: The
end of theadjuster screwishardened andcannot
be ground or re-faced.
CAMSH AFT REMOVAL
1. Remove cam shaft end plug (A).
A
2. Remove camshaft sprocket flange bolt and
washer .
3. Place a clean shop towel in the area below cam
chain sprocket.
4. Remove sprocket from camshaft and chain.
5. Secure cam chain with a wire to prevent it from
falling into the crankcase.
PartShark.com
877-999-5686
To Next Page
Loading...
