BRAKES
9.8
Cap is Even
5in.lbs.(0.56Nm)
Torque Outer Nut First
15. Field test machine at low speed before putting
into service. Checkfor proper braking actionand
lever reserve. With lever firmly applied, lever
reserveshould be no less than1/2″ (1.3cm)from
handlebar.
16. Check brakesystemf orfluidleaksandinspectall
hoses and lines for wear or abrasion. Replace
hose if wear or abrasion is found.
MASTER CYLINDER
REMOV
AL
1. Clean master cylinder and reservoir assembly.
Make sure you have a clean work area to
disassemble brake components.
2. Placeashop towelunder brakelineconnectionat
master cylinder. Loosen banjo bolt; remove bolt
and sealing washers.
CAUTION:
Brake fluid will damage finished surfaces. Do not
allow brake fluid to come in contact with finished
surfaces.
3. Remove master cylinder from handlebars.
4. Hold brake upright and continue to remove
master cylinder. Cover brake line to avoid
spillage.
PartShark.com
877-999-5686
To Next Page
Loading...
