• When you don’t have a camera connected to your paired content and video accessory (for
example, Poly Trio Visual+ or Poly Trio VisualPro), you can receive video but can’t send video.
• Video always displays when a contact can send video and you enable the system to receive video.
Camera Presets on Poly Trio Systems
You can store and modify camera presets on a Poly Trio system with a connected Poly camera.
Note: Presets aren’t supported with the Logitech Webcam C930e camera.
Camera presets are stored camera positions that you can create before or during a call. Presets enable
you to quickly point a camera at predefined locations in a room, which remain until you change them. The
system uses preset 0 as the default camera position for all preset camera positions. This default camera
position is zoomed out, panned straight ahead, with horizontal tilt.
If your system camera supports pan, tilt, and zoom movement, you can create up to 10 preset camera
positions for the near-end camera. Each preset stores the following information:
• Camera number
• Camera zoom level
• Camera direction
• Snapshot of the camera view
Store Camera Presets
You can store camera presets during a call or when the Poly Trio system is idle (if you have a connected
Poly camera).
Note: You can only modify and store camera presets if the gear icon displays in Camera Options
screen.
Procedure
1. Do one of the following:
• Select Camera .
• Select Menu > Camera.
• On the Home screen, select Camera.
2. Adjust the camera to the desired position and zoom level.
3. Select Presets.
The available and stored preset positions display.
4. Press and hold a preset position numbered 0 to 9.
The new position displays immediately.
Video Calls on Poly Trio Systems
51
To Next Page
Loading...
Need help?
General
