14-2
2
+
+
1
‘860’ Radio Remote Control [if tted]
1. To switch on the control, pull the stop button out.
Operation [if tted]
2. To enable the radio remote control to be used,
press both of the safety buttons at the same
time for at least 1 second and a red light will
illuminate. Release the safety buttons and it
will change to green.
3. To switch o the control, push in the stop button
when the plant is not set to radio mode or is not
operating.
4. To conserve the battery charge the hand set
should be switched o when not in use.
5. Store the control in a dry, secure place when
not being used to prevent damage and
unauthorised use.
To Next Page
Loading...