03-3
General Information
EN
9. Metric ISO units are used within this manual.
Units of Measure
12. The copyright of this user manual is reserved
by Terex ®. The right is reserved to alter any
details contained in this manual without notice.
13. This user manual contains information and
technical drawings, which may not be copied,
distributed, altered, stored on electronic media,
revealed to others or used for the purpose of
competition, either partially or in its entirety.
Copyright
Threads and Fasteners
10. Metric threads and fasteners are used
throughout the machine normally.
11. Where a standard component is used on the
machine, the thread and fastener system on
that component may not be metric.
To Next Page
Loading...