Servicing Vibrating Hopper Feeder
1. After the initial 8 hours of operation, renew the
oil in the feed hopper vibrating unit oil baths.
n WARNING
Refer to Safety Notices Section for relevant
warning and procedure
LOCKOUT
PLANT
FALLING
HAZARD
2. Unscrew the plug to drain oil from each oil bath.
Re-t plug to seal.
Vibrating Hopper Feeder - Servicing
3. Fill each oil bath with suitable oil, see
servicing - lubrication plus lubricant and uid
specications.
4. Oil should be level with the line on sight glass.
To Next Page
Loading...