10-2
31
Preparing to Move Plant
1. Before moving the plant it must be cleared of
any material.
2. The discharge end of the product conveyor must
be lowered which, by pivoting, also gives more
ground clearance by raising the base of the
conveyor.
3. Observe all safety warnings.
n WARNING
Prior to attempting any manoeuvring
of the plant the tracks must be free of
obstructions, including crushed material
and nes. Do not push or tow the plant.
Failure to observe this warning could
result in danger to persons and damage
to the plant which may also invalidate
warranty.
Initial Preparation
4. Refer to preparing to nish crushing to make
sure the feed hopper and crusher are empty
and that all materials have run o all of the
conveyors.
5. Clear the tracks of any obstructions and remove
any crushed or ne material and dirt.
To Next Page
Loading...