51-3
2
1
4
Servicing Hydraulic Systems
EN
Hydraulic Fluid Level
n WARNING
Refer to Safety Notices Section for relevant
warning and procedure
LOCKOUT
PLANT
3. It is essential when replenishing hydraulic uid,
attending to lters, etc. to apply the greatest
degree of cleanliness as it is most important
that contaminants are not allowed to enter the
system.
1. Check the uid level on the gauge and top up as
necessary.
4. If hydraulic uid needs to be added to maintain
the correct level, this should be poured in after
removing the return lter cover but with the lter
element left in place.
2. Maximum approximately 40mm (1.5in) below
upper mark.
To Next Page
Loading...