17-3
Powerscreen® XA750S
13
8
F1
EN
NOTICE
If the air inlet lter has been removed
to obtain the minimum transport height,
remove transportation cap and t the air
lter. Store the transportation cap in the
toolbox.
5. Observe all safety instructions.
6. Start the engine, see engine starting, leaving the
engine at its idling speed.
7. The plant control screen will display the last
working screen in use.
8. The plant preparation can only be undertaken
in set-up mode P20. If the plant is not in this
mode, return to screen display P00 by pressing
function button as required.
Initial Preparation
To Next Page
Loading...