14-3
9
7
‘860’ Radio Remote Control [if tted]
EN
6. The radio remote control has a built in NiMH
battery and charging unit.
9. The input charging point on the rear of the
control can accept a charging voltage from
either 12VDC or 24VDC systems.
Battery Recharging
7. Battery charge status is indicated by the light in
the transmitter:
8. The light on the hand set changes from green
to red when there is about 3% power left in
the battery, approximately 1 hour continuous
operation remaining, and indicates it requires
recharging.
10. A charging cable is supplied, suitable for
plugging into a vehicle auxiliary or cigarette
lighter point. Some machines have a 24V
socket on the control panel.
11. Battery capacity is 2000mAh.
12. Charging time from completely empty battery is
approximately 4 hours.
13. Operating time with fully charged battery is
approximately 30 hours.
14. During the charging of the batteries the light
will be red until changing to green when fully
charged. The battery cannot be overcharged.
15. The plant warning horn will also sound when
battery recharging is required.
Red - battery needs charging
Green - battery charged
To Next Page
Loading...