49-3
6
7
42
4
7
41
7
Servicing Magnetic Separator [if tted]
EN
4. Belt tracking should be checked frequently and
adjusted as necessary. To track the belt, the
tail pulley should be moved in a direction to
tighten the belt on the side opposite to the
direction in which the belt wanders. Tighten
the side of the belt to which you want the belt to
move.
5. When tracking or tensioning the belt take care
not to over-tension as this will cause the shaft
bearings to fail.
6. Regularly check the hydraulic motor mounting
bolts for tightness and that both halves of the
coupling between the motor and the drive shaft
are in alignment.
7. Lubricate bearings consistent with schedule in
servicing - lubrication using suitable grease.
n DANGER
As many inspections as possible should
be made whilst the belt is stationary.
When this is not possible extreme care
should be taken when inspecting the
belt whilst it is moving as this creates an
entanglement hazard and risk of trapping
parts of the body.
Servicing
8. Refer to lubricant and uid specications.
To Next Page
Loading...