11-2
13
01
15
12
n/min
8
Unload & Load - Transport Trailer
Unloading from Trailer
1. If the machine has been manufactured to
connect to a special rear bogie, refer to the
special instructions to separate the bogie.
2. Removing the fastenings securing the
machine and any loose items to a trailer is the
responsibility of the haulage contractor.
3. A tracked machine will normally be secured to a
transport trailer.
4. Observe all safety warnings.
5. Make sure suitable ramps are positioned at the
end of the trailer for unloading.
6. Check that any loose items transported with
the machine will not cause a hazard while
unloading.
7. Start the engine, see engine starting.
9. Unload the machine slowly o the trailer into
a safe position or plant operating position,
manoeuvring the machine with the tracks. Use
the umbilical control or the remote radio control,
if tted, see moving the machine.
10. Stop the engine, see engine stop, unless
required further.
NOTICE
On some machines, the air inlet lter
may have been removed to obtain the
minimum transport height, remove
transportation cap and t the air lter.
Store the transport cap in the toolbox.
8. Set the engine at the slowest speed, if
applicable. Some machines have automatic
engine speed control.
To Next Page
Loading...