18-2
17
04
4
6
8
8
Loading the Vibrating Feeder Hopper
Correct Loading of Hopper
1. Observe all safety warnings and notices.
3. Material for crushing must be within the sizes
specied in the crusher capacity of the plant,
refer to specication and plant information.
4. Material for crushing must be fed into the rear
part of the plant hopper on to the base plate
designed for loading.
5. This method will allow feed material to pass
over the feeder bars gradually to allow them to
function correctly.
6. The feed bucket should pass as close as
possible to the hopper top edge, just clearing
the sides or end of the hopper.
7. Empty the bucket to drop material the minimum
height into the hopper base plate.
8. Do not drop material on to the feeder bars as
they are not designed for impact of material
from a great height.
2. Make sure all personnel are clear of the plant as
described in plant location considerations, refer
to preparing to crush.
To Next Page
Loading...