27-2
14
13
17
20
28
20
9
17
'860' Radio Remote Feeder Stop & Start [if tted]
5. Prepare the plant for normal crushing. Refer to
specic plant controls.
9. Press the button to start and stop the feeder.
Alternative icons are used on some plant
controls.
1. Observe all safety instructions.
Radio Remote Control - Feeder Stop & Start, [if tted]
8. The feeder speed on some plants can also be
controlled with the radio, refer to feeder speed
adjust ‘860’, if applicable.
3. Activate the radio remote control, refer to radio
remote ‘860’.
4. Start the engine. Refer to specic plant and
engine controls.
6. Set the plant to normal crushing operation mode
with the plant controls, making sure the feeder
is running.
2. Set up the plant for operation in plant mode.
Refer to specic plant controls.
7. Set the desired feeder speed at the plant
controls or set to automatic, depending upon
the specic controls tted to the plant.
To Next Page
Loading...