Powerscreen XA750S - Initial Start-Up

33-2
82
 43
 51
 03
Initial Checks
1. Check the oil levels in the vibrating unit oil baths.
2. Check the hydraulic oil level in the tank.
NOTICE
Checks on the plant are crucial during the
󰘰rst week of operation.
This section should be read and
understood prior to starting the plant. If
there are any doubts, consult your local
Powerscreen® dealer or Powerscreen®
technical support.
3. Refer to engine manual for initial start up of
engine.
Initial Start-Up
4. Run the plant empty for a short period of time
and check for abnormal noises, vibration or
excessive heat from the shaft bearings.