34-3
03
03
Powerscreen Jaw Plants
EN
10. If inspection reveals the toggle plate and seats
are worn then replacement is required. Do
not modify the jaws or spring system to eect
additional clearance as this may adversely
eect the structural integrity of components
leading to failure and loss of any warranty.
Toggle Beam Slider Pads
12. In applications where the crusher is subjected
to frequent overload release situations, wear on
the slider pads may be accelerated.
13. Regularly check to make sure there is no
rocking movement of the toggle beam. View
through the chassis shim aperture guards whilst
the crusher is running.
14. Excessive wear or damaged pads could result
in movement of the toggle beam or cylinders
in normal operation, which will result in further
machine damage.
15. If the slider pads are worn, these should be
replaced as soon as possible to prevent failure
during crushing.
11. Specialist training and experience are required
for this work, contact your local Powerscreen®
dealer or Powerscreen® technical support for
advice.
16. Specialist training and experience are required
for this work, contact your local Powerscreen®
dealer or Powerscreen® technical support for
advice.
HR - Hydraulic Release Jaw Crushers
To Next Page
Loading...