Powerscreen XA750S - Page 20

AM0009-4
Fuel Transfer Pump [if 󰘰tted]
Top Up With Fuel
NOTICE
Do Not 󰘰ll the tank to over󰘱ow or full
capacity.
Allow room for expansion and wipe up
spilt fuel immediately.
1. Check the fuel gauge on the machine.
2. Observe all safety warnings.
3. Follow the instructions to re-fuel in the machine
user manual
4. Connect both hoses to the pump and insert the
suction hose into the fuel supply.
5. Remove the 󰘰ller cap and insert the delivery
hose into the machine fuel tank.
6. Operate the switch on the pump to top up the
fuel tank. Use only in accordance with the
introduction and speci󰘰cation.
7. When re-fuelling is complete, switch o󰘯 the
pump and stow the hoses.
8. Replace the 󰘰ller cap.
9. If the machine is to be operated, refer to engine
starting in the user manual to start up.
10. If the machine is not being used, set the
isolation switch to the ‘0’ position.
n DANGER
Diesel fuel is highly 󰘱ammable and is an
explosion/burns hazard. NEVER remove
the 󰘰ller cap or re-fuel, with the engine
running.
NEVER add petrol, gasoline or any other
fuel mixes to diesel because of increased
󰘰re or explosion risks.
DO NOT smoke while re󰘰lling or carrying
out maintenance on the fuel system. DO
NOT carry out maintenance on the fuel
system near naked lights or sources of
sparks, such as welding equipment.