02-15
Safety Hazards
EN
Transporting, Manoeuvring and Re - commissioning
3. The machine is remote controlled and may start
without notice. Stay clear of the machine.
4. The machine must be loaded and transported
only in accordance with the operating
instructions.
5. For manoeuvring the machine, observe the
prescribed transport position, admissible speed
and itinerary.
6. Use only appropriate means of transport and
lifting equipment where applicable of adequate
capacity.
7. The re-commissioning procedure must be strictly
in accordance with the operating instructions.
8. Before travelling with the machine, check that
the braking and any signalling and lighting
systems are fully functional.
9. Before setting the machine in motion always
check that the accessories have been safely
stowed away.
10. When travelling on public roads, ways and
places, always observe the valid trac
regulations and, if necessary, ensure
beforehand that the machine is in a condition
compatible with these regulations.
11. In conditions of poor visibility and after dark,
always switch on the lighting system of the
transporting vehicle.
12. When crossing underpasses, bridges and
tunnels or when passing under overhead
lines always make sure that there is sucient
clearance.
13. Never travel across slopes; always keep the
working equipment and the load close to the
ground, especially when travelling downhill.
14. On sloping terrain, always adapt your travelling
speed to the relevant ground conditions. Never
change to a lower gear on a slope. Always
change gear before reaching a slope.
To Next Page
Loading...