Table of contents
1 Operating Concept.................................................................................................. 8
1.1 Functions of the keys .................................................................................. 11
1.2 Changes the set operating language........................................................... 12
1.3 Acknowledging Error or Warning Messages ............................................... 13
1.4 Key Lock ...................................................................................................... 13
2 Entries in the
[Menu]
display................................................................................. 14
3 ID Code................................................................................................................. 15
3.1 A complete measuring station may comprise the following:......................... 17
4 Safety and Responsibility..................................................................................... 18
4.1 Explanation of the safety information........................................................... 18
4.2 General safety notes.................................................................................... 19
4.3 Intended Use................................................................................................ 20
4.4 Users' qualifications...................................................................................... 21
5 Functional description........................................................................................... 23
6 Assembly and installation..................................................................................... 24
6.1 Scope of supply............................................................................................ 26
6.2 Mechanical Installation................................................................................. 26
6.2.1 Wall mounting............................................................................................ 26
6.2.2 Control Panel Installation.......................................................................... 28
6.3 Electrical installation..................................................................................... 31
6.3.1 Specification of the threaded connectors.................................................. 32
6.3.2 Terminal diagram...................................................................................... 33
6.3.3 Cable Cross-Sections and Cable End Sleeves......................................... 42
6.3.4 Wall mounting and control panel installation............................................. 43
6.3.5 Switching of inductive loads...................................................................... 44
6.3.6 Connect the sensors electrically to the controller...................................... 45
6.4 Priming to bleeding....................................................................................... 49
7 Commissioning..................................................................................................... 50
7.1
Switch-on behaviour during commissioning................................................. 50
7.2 Adjusting the backlight and contrast of the controller display....................... 51
7.3 Resetting the operating language................................................................ 51
7.4 Defining metering and control processes..................................................... 51
Table of contents
3
To Next Page
Loading...
