ProMinent DULCOMETER - Information on the measured variables

Measured variable Meaning Unit
[mA general]
n [Freely selectable]
n [%]
n [mA]
n [m]
n [bar]
n [psi]
n [m
3
/h]
n [gal/h]
n [ppm]
n [%RF]
n [NTU]
[Bromine] Bromine [ppm]
[Chlorine] Chlorine [ppm]
[Chlorine dioxide] Chlorine dioxide [ppm]
[Chlorite] Chlorite [ppm]
[Fluoride [mA]] Fluoride [ppm]
[Oxygen] Oxygen [ppm]
[Ozone] Ozone [ppm]
[Peracetic acid] Peracetic acid [ppm]
[Hydrogen per.] Hydrogen peroxide with a [PER]
sensor type
[ppm]
[Cond. (mA)] Conductivity sensor with mA signal [µS]
[Temp. [mA]] Temperature sensor with mA signal [°C] or [°F]
[Temp.[Pt100x]] Temperature with a Pt 100 or Pt 1000
sensor type
[°C] or [°F ]
When you perform the measurement of the pH value with potential equalisation, you
have to set this procedure when selecting the measured variable as a parameter.
Setting measured variables
53